Embroidered patches can be dated all the way back to ancient Asian civilizations; they have existed for years and years. Yet not until recently has it been possible to place them to your clothing utilizing a hot iron and heat-activated glue. With today’s patches you can readily apply them on most fabrics without ever needing a needle and thread. Thankfully having the capacity to affix them with a hot iron implies that the fingers are not going to get sore and it is much easier and quicker to do. The only issue is, you can’t iron patches to leather – at least in the traditional sense.
When you’re utilizing a hot iron to install embroidered patches you’re essentially warming up the glue on the back side till it reaches a semi liquid, tacky state. That will require a lot of heat; heat that can damage the sensitive finish of leather.
It’s correct that leather is a very durable material, nevertheless the surface is comfortably damaged by concentrated heat sources. This presents two problems. The very first problem would be the fact when the leather is damaged, the glue are not going to stick to it and then the patch will fall off. And when the patch does fall off, the leather will likely be left having an ugly mark in which the iron has burned it. Exactly the same can be stated for vinyl and various types of faux leather. Another thing to consider is the fact even though you might try to make the glue adhere, one slip from the iron which brings in contact with bare leather will leave a burn mark. This is the reason you ought to never have a hot iron anywhere near your leather.
We said earlier that you simply can’t work with an iron to set embroidered patches to leather inside the traditional sense. The explanation for saying this is because that while you must not make an effort to place iron on patches to leather within the traditional way but there’s a non-traditional method. Therefore there is special glue which you can use along with an unheated iron. Yes, a smeynb iron. It will only be important to use your iron as being a press.
To get this to function properly, you will need to have special glue; leather is notoriously difficult to do business with so you won’t have the capacity to use just any old glue. You can find this specialized glue at craft stores, sewing shops, and also some high-end leather goods specialty stores. Just be sure you carefully browse the directions on the bottle, making sure that use on leather products is specifically mentioned. Failure to get this done could imply that you’re just going to be squandering your money.
The glue must be applied to the rear of the patch according to the instructions on the bottle and then you should carefully put the patch onto the portion of the leather where you want it. Next thing you have to do is make use of cold iron to press down firmly onto the patch for the quantity of time as stated on the glue bottle. After that you can release the iron and wait for a glue to dry. It’s essential that you know where you want to have your patch before you decide to lay it down. You will end up left with the ugly stain in the event you remove the patch after you might have placed it to the leather.